When the burned area of ​​the air-cushion burns is small, it is filled with asbestos thread; when the burned-out area is large, a piece of shimming can be cut from the same part of the waste cylinder gasket of the same thickness, and carefully knocked on to make it fit well; if burned, Between the two cylinders, the asbestos thread should be wrapped in copper. If the radiator breaks and leaks into and out of the water hose, if it breaks a little, use an adhesive cloth to coat the leaky place with soap, and then use a wire to tie it tightly. If it is severely broken, cut it into two pieces with a knife from the broken place of the hose. Use a suitable bamboo tube. Such as sets in between the hose, and then tied with a wire and then can be installed; radiator core copper pipe with a slight leak, the soap can be used to the leak. If the leak is serious, use pliers to clamp the leak so that it does not leak. If the valve spring breaks only one break, the two break springs can be installed and used. If the spring breaks several places, the multi-cylinder machine can remove the adjusting bolts of the inlet and exhaust valves of the cylinder and close the valve to stop the cylinder. Work, while cutting off the oil. Sudden power cut in the middle When the horn does not ring suddenly, the light is completely off, and the starter does not turn, it means that the vehicle is completely off. At this time, you can first check whether the pile head of the battery is loose. Do not squawk when inspecting. You can use a pair of pliers to test the two pile heads. If there is no spark, then the pile head is loose, tighten with a wrench; if the pile head is tight and clean, the power failure phenomenon is still not eliminated. , can check the connection of the two-pole wire, such as poor contact, timely repair; if the battery has a single cell damage, the copper wire can be used directly to connect a good cell. If the clutch is tightened, if the system rubs with oil, press down the clutch pedal, fill the gasoline with the oil gun, shoot at the gap between the flywheel friction plate and the clutch pressure plate, and make the above oil dissolve, then temporarily use it (if no oil When guns and substitutes are used, plastic pipes or rubber hoses can be used to suck and align the shots; if the friction plates slip due to burning, the burned parts can be roughened, but the starting should be smooth while driving, and the speed change action should be rapid. Break the leaf spring according to the situation. In the case of steel plate springs, wooden blocks on the axles and shelves, temporarily tied with iron wire, etc., drive to the repair point for replacement. No jacks to replace the tires to replace the double row of tires, the internal wheel can be used to block up the wooden block or brick, so that the outer wheel is vacant, you can remove; replace the front wheel or single tire, the available wood or brick, stone before The shaft or rear axle pad is stable, digging below the tire to be removed so that the tire is vacant, it can be replaced. Damaged fan tape The fan tape is damaged and is mostly broken. Several ropes can be used for tightening the ropes. The length and thickness of the ropes should be similar to those of the original fan tape, but the ropes should be wound in the middle and cannot be exposed. Then they can be tightly tied with iron wires; Holes, temporarily connected with coarse wire. However, the law should test the engine for a few minutes to check if the fan rotation is normal. Source: Extracted from Heilongjiang Science and Technology News.-2005.8.3.-2
