Installation of S49-A stamping grid type ternary vibrating screen Label Keywords: vibrating screen, ternary vibrating screen Finishing release: high machine screen date: 2010-12-2
First, the installation of the stamping grid type three-way vibrating sieve bottom grid
1. Put the No. 1 seal on the lower edge of the bottom grid;
2, put the bottom of the grid on the sieve tray, pay attention to the anastomosis of the upper and lower bumps;
3. Install the No. 2 vertical ring and then lock it;
4, put the tow board on the bottom of the grid, put the ball ring, the general S49-1000 type sieve machine, put about 20 ball rings, each ball bounce ball 2-3 balls.
Second, the installation of stamping grid and screen
1. Lay the screen on the workbench and press the net rack;
2, put on the No. 1 seal, tighten the screen, and then cut off the excess screen;
3. Place the mesh frame with the screen on the tow board and press it firmly on the screen;
4. Put on the 2nd vertical ring to lock, then use the leather hammer to beat around the vertical ring and lock again.
Third, the installation of stamping grid type three-way vibrating screen dust cover
1. Install the No. 3 seal on the upper edge of the sieve, the narrow side of the seal is down, and the wide side is on;
2. Align the dust cover on the screen;
3. Install the No. 1 vertical ring and lock it.
This information is published by Gaofu Company. Please indicate the source.
Closed Pouch,Medical Closed Pouch,Two Piece Closed Pouch
Henso Medical Co., Ltd. , http://www.hzurology.com