2. The equipment used to add lubricant should be clean. Lubricate the grease, dust, and grease of the grease nipple, lubrication port, and lubrication before lubrication.
3. Always check the working temperature of bushings, bearings and other frictional parts. If oil seals are found to leak oil and the working temperature is too high, they should be repaired and lubricated at any time.
4. The sprocket and chain should be lubricated under the condition of parking. When the oil is lubricated, the sludge on the chain should be removed and evenly wiped.
5. The clutch release bearing and bushing must be disassembled and lubricated. It is usually carried out once a year.
6, after the end of the test operation of the combine harvester, or after a long time operation, the gear oil, engine oil sump oil should be replaced or filtered before use. It is usually checked once a week. The oil spill was found immediately and the oil level was insufficient.
7. The wooden bearing tile of the reel and other parts should be immersed in the oil at 120°C～130°C for 2 hours before use, and then be greased and installed.
8, be sure to add enough butter. When the filling does not go in, it can be added after rotating the lubrication area until it is full.
9. Each lubrication part, detachable bearing, bushing, slider, etc. shall be combined with maintenance work, cleaned with oil, and filled with lubricant after assembly.
10. All oil-bearing bearings should be unloaded after the end of each season and soaked in hot oil for 2 hours.
PE Coated Nonwoven,Non Woven Filter Fabric,Nonwoven Lamination Material,PE Coated PE Lamination
XINLE HUABAO MEDICAL PRODUCTS CO.,LTD. , https://www.golbaltravel.com